What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

Last Updated: 02.07.2025 08:57

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

Edit 2024–10.

the problem then depends on "how fast does the fuse operate?".

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

China consumer prices slump again, deepening deflation worries as demand stays weak - CNBC

2024–10–10[John johnson John Johnson ]

One is “what exactly is in a ‘surge protector’ ? ”

At least they know the answer if they wanted it.

Jamie Dimon: The economy could ‘deteriorate’ soon - CNN

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

He then describes the function of a fuse.

The third is lightning and “how it gets conducted into a home.”

Can machine learning and AI make programmers obsolete? Can AI make software coding and debugging a thing of the past?

Because the load is inductive, the current lags the voltage.(by a bit).

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

Rangers Option Kumar Rocker - MLB Trade Rumors

but this device (an Inductor) … impedes the rapid changes in the current.

2024–10–14 [Omar Gharbi Omar Gharbi ]

but I think this circuit , shows a few more pieces.

How should one handle an uninvited guest at a small, intimate wedding ceremony? Is it appropriate to ask them not to attend?

Can the fuse protect the electronic devices from lightning instead of a surge protector.

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

He then asserts :

Kristen Doute gives birth to rainbow baby with fiancé Luke Broderick - Page Six

so, what happens?

Now when you have a certain ac resistance, then a current flows in a loop.

A fuse is a non-resetable over current circuit protector.

This Case Forced Me to Completely Rethink How I Handle the Switch 2 - Gizmodo

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.

I post the exact comment here.

These are simplified answers to the original question, and does not change anything I wrote above.

Signs of iPhone 17 Air Spotted in iOS 26 Beta 2 - MacRumors

An AC voltage/ current source, and an ac inductive load.

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

For this case there are devices called Metal oxide varistors (MOV).

Why is Luigi Mangjone being seen as courageous if he was too cowardly to look his victim in the eyes? Don't Hollywood heroes look their victims in the eyes when shooting/stabbing/choking them?

what exactly is a ‘surge’ protector?

(Dc diagram shown, AC is similar).

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

How to Watch Tonight's NBA Finals Indiana Pacers vs. Oklahoma City Thunder Game 1 for Free - CNET

a photo is worth a thousand words.

But… the neutral is now “floating” because of the 1 ohm resistance.

Here is a simplified AC power diagram.

Exclusive | Nile Rodgers recalls becoming ‘really close’ with the late Sly Stone: ‘He was living in a car’ - New York Post

Upvotes:

nine

The other is “what does a “fuse” do?”

A doctor shares the 7 supplements he takes a day to reduce inflammation, prevent heart disease, and support metabolism - Business Insider

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

But it can get overloaded, and no longer works.

This device then solves the entire problem.

After trying to buy Ilya Sutskever’s $32B AI startup, Meta looks to hire its CEO - TechCrunch

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

[old diagram got deleted by accident]

The bolt then partially travels down the line to your home.

Pacific sediment cores unlock millions of years of climate history - Earth.com

So, the voltage could go up to 500 volts, and the fuse will not open up.

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

He then describes Rainy Season and Lightning.

It seems Mohan does not understand the difference between a comment and an Answer.

A circuit breaker is similar, but is resettable.

This is where this question deviates from being a 'generic' question, and becomes more specific.

One

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.

eight

First Sentence:

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

This one hit behind the barn.

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).

There are three different concepts here that are getting confused.

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.

This is where the MOV conducts again, and dissipated the energy.

It also is a device that limits the change in current flow.

What does a fuse do?

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

2024–10–16 [ OO OLAOYE OYEBODE ]

The MOV will conduct when the voltage exceeds 50% of line voltage.

Barnstars:

[image of Common-mode choke]

What is lightning?

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

In schematic diagrams this is the symbol for a fuse:

There are two important concepts here.

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

This is 'the assistant's answer'

This is the picture of an electronic coil of wire wound around a core of magnetic material.

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

These devices are installed between the “hot” and “neutral” and protective ground.

At one ohm, the resistor has a maximum of 1 watt power.